Article

Ahmed, M. and Faisal, M. and Laskar, A. and Abdullah, A. and Shahadat, M. and Umar, K. and Kamyab, H. and Ubaidullah, M. and Pandit, B. and Prakash, C. and Yusuf, M. (2023) Experimental studies for thin layer model validation and microwave drying characteristics of beetroot considering energy optimization. Fuel, 346.

Soni, A. and Das, P.K. and Yusuf, M. and Ridha, S. and Kamyab, H. and Alam, M.A. and Masood, F. and Chelliapan, S. and Ubaidullah, M. and Pandit, B. and Prakash, C. (2023) Synergy of silica sand and waste plastics as thermoplastic composites on abrasive wear characteristics under conditions of different loads and sliding speeds. Chemosphere, 323.

Nishat, A. and Yusuf, M. and Qadir, A. and Ezaier, Y. and Vambol, V. and Ijaz Khan, M. and Ben Moussa, S. and Kamyab, H. and Sehgal, S.S. and Prakash, C. and Yang, H.-H. and Ibrahim, H. and Eldin, S.M. (2023) Wastewater treatment: A short assessment on available techniques. Alexandria Engineering Journal, 76. pp. 505-516.

Ali, S. and Abdul Rani, A.M. and Altaf, K. and Hussain, P. and Prakash, C. and Hastuty, S. and Rao, T.V.V.L.N. and Aliyu, A.�A.A. and Subramaniam, K. (2019) Investigation of alloy composition and sintering parameters on the corrosion resistance and microhardness of 316L stainless steel alloy. Lecture Notes in Mechanical Engineering. pp. 532-541. ISSN 21954356

Aliyu, A.�A.A. and Abdul-Rani, A.M. and Ginta, T.L. and Prakash, C. and Rao, T.V.V.L.N. and Axinte, E. and Ali, S. (2019) Synthesis and characterization of bioceramic oxide coating on Zr-Ti-Cu-Ni-Be BMG by electro discharge process. Lecture Notes in Mechanical Engineering. pp. 518-531. ISSN 21954356

Prakash, C. and Singh, S. and Singh, M. and Antil, P. and Aliyu, A.A.A. and Abdul-Rani, A.M. and Sidhu, S.S. (2018) Multi-objective Optimization of MWCNT Mixed Electric Discharge Machining of Al�30SiCp MMC Using Particle Swarm Optimization. Materials Horizons: From Nature to Nanomaterials. pp. 145-164. ISSN 25245384

Aliyu, A.A. and Abdul-Rani, A.M. and Ginta, T.L. and Prakash, C. and Axinte, E. and Razak, M.A. and Ali, S. (2017) A Review of Additive Mixed-Electric Discharge Machining: Current Status and Future Perspectives for Surface Modification of Biomedical Implants. Advances in Materials Science and Engineering, 2017. ISSN 16878434