Article

Ridha, S. and Dzulkarnain, I. and Abdurrahman, M. and Ilyas, S.U. and Bataee, M. (2022) Microstructural properties and compressive strength of fly ash-based geopolymer cement immersed in CO2-saturated brine at elevated temperatures. International Journal of Environmental Science and Technology, 19 (8). pp. 7589-7598. ISSN 17351472

Moradi, B. and Ayoub, M. and Bataee, M. and Mohammadian, E. (2020) Calculation of temperature profile in injection wells. Journal of Petroleum Exploration and Production Technology, 10 (2). pp. 687-697. ISSN 21900558

Zamani, A. and Bataee, M. and Hamdi, Z. and Khazforoush, F. (2019) Application of smart nano-WBM material for filtrate loss recovery in wellbores with tight spots problem: an empirical study. Journal of Petroleum Exploration and Production Technology, 9 (1). pp. 669-674. ISSN 21900558

Hematpour, H. and Mahmood, S.M. and Nasr, N.H. and Karimi, M. and Bataee, M. (2019) Experimental investigation on the mobility reduction factor of surfactant-alternating-gas foam flooding. Kuwait Journal of Science, 46 (4). pp. 75-82. ISSN 23074108

Bataee, M. and Irawan, S. (2018) Porosity and permeability alteration around wellbore during injection process. International Journal of Geomechanics, 18 (2). ISSN 15323641

Moradi, B. and Ayoub, M. and Bataee, M. (2018) Sensitivity analysis of the parameters affecting temperature and pressure profiles along the wellbore. Petroleum and Coal, 60 (6). pp. 1291-1303. ISSN 13377027

Bataee, M. and Irawan, S. and Namazi-saleh, F. and Ridha, S. (2017) Development of stress model near the wellbore using an iterative coupling method. International Journal of Geomechanics, 17 (2). ISSN 15323641

Bataee, M. and Irawan, S. and Ridha, S. and Hematpour, H. and Hamdi, Z. (2017) Wellbore failure during water-alternating-gas injection by use of flow-stress coupling method. SPE Journal, 22 (1). pp. 172-183. ISSN 1086055X

Bataee, M. and Irawan, S. and Ridha, S. (2016) Wellbore stability model based on iterative coupling method in water alternating gas injection. Journal of Petroleum Exploration and Production Technology, 6 (4). pp. 755-775. ISSN 21900558

Bataee, M. and Irawan, S. and Kamyab, M. (2014) Artificial neural network model for prediction of drilling rate of penetration and optimization of parameters. Journal of the Japan Petroleum Institute, 57 (2). pp. 65-70. ISSN 13468804

Conference or Workshop Item

Bataee, M. and Hebah, M.A. and Shabib-Asl, M. and Hamdi, Z. and Moradi, B. and Ridha, S. (2023) Determination of Optimal Distance Between Wells in SAGD and VAPEX Methods Using Reservoir Simulation. In: UNSPECIFIED.

Bataee, M. and Carter, R. and Hamdi, Z. and Ridha, S. (2023) Feasibility Study and LCoE Analysis of Geothermal Energy Production from Depleted Oil Fields and Gas Prospects Onshore Sarawak, Malaysia. In: UNSPECIFIED.

Krishna, S. and Ridha, S. and Ilyas, S.U. and Campbell, S. and Bhan, U. and Bataee, M. (2021) Application of deep learning technique to predict downhole pressure differential in eccentric annulus of ultra-deep well. In: UNSPECIFIED.

Hamdi, Z. and Momeni, M.S. and Meyghani, B. and Zivar, D. and Chung, B.Y. and Bataee, M. and Asadian, M.A. (2019) Oil well compressive strength analysis from sonic log; A case study. In: UNSPECIFIED.

Bataee, M. and Hamdi, Z. and Irawan, S. and Ashena, R. and Ghassemi, M.F. (2017) Effect of saturation alteration on wellbore stability during WAG Injection. In: UNSPECIFIED.

Hamdi, Z. and Awang, M. and Bataee, M. and Vatanparast, M. (2017) Proposing low temperature CO2 for enhancing miscibility in high temperature reservoirs. In: UNSPECIFIED.

Hamdi, Z. and Awang, M. and Bataee, M. and Kamyab, M. (2016) Cold CO2 injection for balancing interfacial tension decrease and viscosity increase. In: UNSPECIFIED.

Hamdi, Z. and Awang, M. and Basyouni, A. and Hematpour, H. and Bataee, M. (2016) Comparison of CO2 and nitrogen injection at low temperatures in high temperature reservoirs for improving oil recovery. In: UNSPECIFIED.

Bataee, M. and Irawan, S. and Ridha, S. and Hematpour, H. and Hamdi, Z. (2016) Effects of injection pressure on wellbore stress using flow-stress coupling method. In: UNSPECIFIED.