eprintid: 6831
rev_number: 2
eprint_status: archive
userid: 1
dir: disk0/00/00/68/31
datestamp: 2023-11-09 16:18:38
lastmod: 2023-11-09 16:18:38
status_changed: 2023-11-09 16:07:46
type: article
metadata_visibility: show
creators_name: Shukrullah, S.
creators_name: Mohamed, N.M.
creators_name: Shaharun, M.S.
creators_name: Naz, M.Y.
title: Effect of Ethylene Flow Rate and CVD Process Time on Diameter Distribution of MWCNTs
ispublished: pub
keywords: Atmospheric movements; Atmospheric pressure; Carbon; Carbon nanotubes; Catalysts; Deposition; Ethylene; Flow rate; Fluidized bed process; Fluidized beds; Nanotubes; Scanning electron microscopy; Transmission electron microscopy; Vapor deposition; Yarn, Carbon concentrations; Chemical vapor depositions (CVD); Diameter distributions; FBCVD; Fluidized bed chemical vapor deposition; Inverse relationship; MWCNTs; Precursor flow rates, Chemical vapor deposition
note: cited By 10
abstract: To date, focus of the research activities in nanoscience was to control the chemical vapor deposition (CVD) growth of carbon nanotubes (CNTs) by changing the precursor pressure and process temperature. The effect of the precursor flow rate and process time on CNTs growth parameters has been overlooked in past studies and therefore is very little known. This study was focused on the optimization of the ethylene flow rate and CVD process time for CNTs growth over Fe2O3/Al2O3 catalyst in a fluidized bed chemical vapor deposition (FBCVD) reactor, operating at atmospheric pressure. Argon and hydrogen were considered as the carrier and supporting gases, respectively. Transmission electron microscope (TEM) and Scanning Electron Microscopy (SEM) were used to investigate the surface morphology, nanostructures, purity and yield of the grown CNTs. In-depth analysis revealed an increase in tube length, yield and the carbon concentration with ethylene flow rate in the range of 50�110sccm. However, an inverse relationship between flow rate and tube diameter distribution was predicted in the given work. The most favorable results were obtained at an ethylene flow rate of 100 sccm and a CVD process time of 60 minutes. The dense and homogeneous growth of relatively pure nanotubes of increased tube length and narrow diameter distribution, in the range of 20�25nm, was observed at optimized flow rate and process time. © Taylor & Francis Group, LLC.
date: 2016
publisher: Taylor and Francis Inc.
official_url: https://www.scopus.com/inward/record.uri?eid=2-s2.0-84964685749&doi=10.1080%2f10426914.2015.1090588&partnerID=40&md5=ec823349a75848b479db09bfb1290b38
id_number: 10.1080/10426914.2015.1090588
full_text_status: none
publication: Materials and Manufacturing Processes
volume: 31
number: 12
pagerange: 1537-1542
refereed: TRUE
issn: 10426914
citation:   Shukrullah, S. and Mohamed, N.M. and Shaharun, M.S. and Naz, M.Y.  (2016) Effect of Ethylene Flow Rate and CVD Process Time on Diameter Distribution of MWCNTs.  Materials and Manufacturing Processes, 31 (12).  pp. 1537-1542.  ISSN 10426914