eprintid: 5514
rev_number: 2
eprint_status: archive
userid: 1
dir: disk0/00/00/55/14
datestamp: 2023-11-09 16:17:15
lastmod: 2023-11-09 16:17:15
status_changed: 2023-11-09 16:01:56
type: article
metadata_visibility: show
creators_name: Al-Batati, N.
creators_name: Hashim, F.M.
creators_name: Pao, K.S.
title: Simulation of drill string vibration inside well bore due to Riser's Oscillation
ispublished: pub
note: cited By 1
abstract: This study attempts to explain the motion behavior of the marine riser coupled to drill string when the vortex induced vibration is involved. Vibrations have been reported to have a major effect on drilling performance, affecting the Rate of Penetration (ROP), causing severe damage to drilling tools and also reduces the efficiency of the drilling process. There are two major components of drilling tools that are subjected to vibration, namely the marine riser and the drilling string. Analysis of vibration in the marine riser and drill string are two topical areas that have individually received considerable attention by researchers in the past. While these two subjects are interrelated, borne by the fact that the marine riser encapsulates and protects the drill pipe, they have been little attempt to investigate them together as an assembly. Due to the complexities of the models, simplifying assumptions were made in order to undertake the investigation. Using staggered approach, the results were compared with experimental and simulation data from the open literature. It was found that the maximum displacement with negative damping occurs at low frequency and rotation speed. The addition of vortex shedding forces caused the drill string to deform from its vertical axis and thus increased the risk of failure of drill string and riser. © Maxwell Scientific Organization, 2014.
date: 2014
publisher: Maxwell Science Publications
official_url: https://www.scopus.com/inward/record.uri?eid=2-s2.0-84888776830&doi=10.19026%2frjaset.7.237&partnerID=40&md5=4ca0bc32de7c1a71ca85aed542f55dfe
id_number: 10.19026/rjaset.7.237
full_text_status: none
publication: Research Journal of Applied Sciences, Engineering and Technology
volume: 7
number: 1
pagerange: 174-182
refereed: TRUE
issn: 20407459
citation:   Al-Batati, N. and Hashim, F.M. and Pao, K.S.  (2014) Simulation of drill string vibration inside well bore due to Riser's Oscillation.  Research Journal of Applied Sciences, Engineering and Technology, 7 (1).  pp. 174-182.  ISSN 20407459