eprintid: 5500
rev_number: 2
eprint_status: archive
userid: 1
dir: disk0/00/00/55/00
datestamp: 2023-11-09 16:17:14
lastmod: 2023-11-09 16:17:14
status_changed: 2023-11-09 16:01:53
type: article
metadata_visibility: show
creators_name: Keong, W.T.
creators_name: Ahmad, F.
creators_name: Sharif, S.
creators_name: Moinser, M.A.
title: Effects of drilling generated heat on damage factor in GFRP
ispublished: pub
keywords: Drilling; Drills; Epoxy resins; Glass fibers; Heating; High speed steel; Resins; Surface measurement, Damage factor; Drilled holes; Drilling parameters; Infrared thermometers; Maximum temperature; Resin matrix; Vacuum resin infusions; Woven glass fibers, Infill drilling
note: cited By 4; Conference of 2013 International Conference on Advanced Materials Engineering and Technology, ICAMET 2013 ; Conference Date: 28 November 2013 Through 29 November 2013; Conference Code:101903
abstract: Drilling generated heat is considered to have significant effect on the product. In this study, woven glass fiber reinforced epoxy composites were fabricated using Vacuum Resin Infusion technique. The composites were drilled using HSS twist drill bit at various drilling parameters. The temperature during drill was measured using infra red thermometer. The damage factor of drilled holes was measured using 3D non-contact surface measurement and correlates it with temperature. Results showed that low feed rate recorded maximum temperature and high fede rate showed lower heat generated during drilling. Damage factor measured at lower feed rate was high and low at high feed rate. This was considered due to evaporation of resin matrix. Copyright © 2014 Trans Tech Publications Ltd, Switzerland.
date: 2014
publisher: Trans Tech Publications Ltd
official_url: https://www.scopus.com/inward/record.uri?eid=2-s2.0-84891839383&doi=10.4028%2fwww.scientific.net%2fKEM.594-595.661&partnerID=40&md5=21be9df95bcb855a00950ee40df0d4ba
id_number: 10.4028/www.scientific.net/KEM.594-595.661
full_text_status: none
publication: Key Engineering Materials
volume: 594-59
place_of_pub: Bandung
pagerange: 661-665
refereed: TRUE
isbn: 9783037859377
issn: 10139826
citation:   Keong, W.T. and Ahmad, F. and Sharif, S. and Moinser, M.A.  (2014) Effects of drilling generated heat on damage factor in GFRP.  Key Engineering Materials, 594-59.  pp. 661-665.  ISSN 10139826