eprintid: 4634
rev_number: 2
eprint_status: archive
userid: 1
dir: disk0/00/00/46/34
datestamp: 2023-11-09 16:16:20
lastmod: 2023-11-09 16:16:20
status_changed: 2023-11-09 15:58:57
type: article
metadata_visibility: show
creators_name: Ahmad, M.A.R.
creators_name: Nasiruddin, Z.R.
creators_name: Rao, T.V.V.L.N.
creators_name: Altaf, K.
title: Overcoming limitation in DFM using layer manufacturing
ispublished: pub
keywords: 3D printers; Durability; Elastomers; Manufacture; Printing; Rubber; Silicones, Design for Manufacturing; DFM; External components; Layer manufacturing; Material durability; Product failures; Scaffolding; Silicone rubber, Rubber applications
note: cited By 0; Conference of 5th International Conference on Mechanical and Manufacturing Engineering 2014, ICME 2014 ; Conference Date: 29 October 2014 Through 30 October 2014; Conference Code:110759
abstract: Design and fabrication of an object with parts embedded internally within the part has always been a difficult challenge to fabricate. This is mainly due to limitations in design for manufacturing (DFM). The objective of this work is to investigate improvements in overcoming limitations in DFM of non-metallic object with embedded part within a part through 3D printing technology and silicone rubber. 3D printing technology is a type of Rapid Prototyping (RP) method which has limitations in its material durability and product failure rate. This technology combined with silicone rubber is envisaged capable to overcome some of the limitations in DFM while increasing its durability. Layer manufacturing using 3D printing is used to construct scaffolding of the end product and silicone rubber used as material to fill the cavities. The end product is a unique �one-piece� outdoor water-feature cage that has no assembly of parts between its various internal and external components which entraps a free rotating ball feature inside the cage. Both limitations in DFM of a part within a part and improving prototype materials durability had been overcome. © (2014) Trans Tech Publications, Switzerland.
date: 2014
publisher: Trans Tech Publications Ltd
official_url: https://www.scopus.com/inward/record.uri?eid=2-s2.0-84921650651&doi=10.4028%2fwww.scientific.net%2fAMM.660.94&partnerID=40&md5=37a7cc2a85e09ebbbc6a01f34252cef7
id_number: 10.4028/www.scientific.net/AMM.660.94
full_text_status: none
publication: Applied Mechanics and Materials
volume: 660
pagerange: 94-98
refereed: TRUE
isbn: 9783038352785; 9783038352785
issn: 16609336
citation:   Ahmad, M.A.R. and Nasiruddin, Z.R. and Rao, T.V.V.L.N. and Altaf, K.  (2014) Overcoming limitation in DFM using layer manufacturing.  Applied Mechanics and Materials, 660.  pp. 94-98.  ISSN 16609336