eprintid: 20601
rev_number: 3
eprint_status: archive
userid: 1
dir: disk0/00/02/06/01
datestamp: 2026-07-06 07:37:09
lastmod: 2026-07-06 07:37:09
status_changed: 2026-07-06 07:37:09
type: article
metadata_visibility: show
creators_name: Ghani, Jaharah A.
creators_name: Yaqoob, Saima
creators_name: Jouini, Nabil
creators_name: Juri, Afifah Zakiyyah
creators_name: Haron, Che Hassan Che
creators_name: Muhamad, Shalina Sheik
title: Performance evaluation of multilayer coated carbide tools in machining hardened AISI430 at high cutting speed under minimum quantity lubrication
ispublished: pub
note: Cited by: 3
abstract: This study focuses on investigating the cutting tool performance of a chemical vapor deposition (CVD) coated carbide tool in machining hardened AISI 4340 alloy steel under environmentally friendly sustainable minimum quantity lubrication (MQL) environment. The input parameters for turning experiments were configured in a high-speed regime, with the cutting speed (V) varying from 300 to 400 m/min, the feed rate (F) between 0.1 and 0.2 mm/rev, and depth of cut (DOC) in the range of 0.2 to 0.4 mm using a multilayer coated carbide tools TiCN/Al<sub>2</sub>O<sub>3</sub>. The experiments were randomly conducted using the Taguchi method L9 orthogonal array, which accommodated three factors, each with three levels. The longest tool life of 7.10 min was noticed under low machining parameters at a cutting speed, V=300 m/min, F=0.1 mm/rev, and DOC=0.2 mm. Analysis using S/N ratio revealed that the machining speed has a most profound influence on tool life in comparison to feed rate and depth of cut. Wear mechanisms such as cutting-edge chipping was commonly observed, whereas at high depth of cut catastrophic failure was noticed due to the flaking of the cutting tool material. © 2024, Malaysian Tribology Society (Mytribos). All rights reserved.
date: 2024
publisher: Malaysian Tribology Society (Mytribos)
official_url: https://www.scopus.com/pages/publications/85205957405?origin=resultslist
full_text_status: none
publication: Jurnal Tribologi
volume: 42
pagerange: 146 - 160
refereed: TRUE
issn: 22897232
citation:   Ghani, Jaharah A. and Yaqoob, Saima and Jouini, Nabil and Juri, Afifah Zakiyyah and Haron, Che Hassan Che and Muhamad, Shalina Sheik  (2024) Performance evaluation of multilayer coated carbide tools in machining hardened AISI430 at high cutting speed under minimum quantity lubrication.  Jurnal Tribologi, 42.  146 - 160.  ISSN 22897232