TY  - JOUR
A1  - Ghani, Jaharah A.
A1  - Yaqoob, Saima
A1  - Jouini, Nabil
A1  - Juri, Afifah Zakiyyah
A1  - Haron, Che Hassan Che
A1  - Muhamad, Shalina Sheik
TI  - Performance evaluation of multilayer coated carbide tools in machining hardened AISI430 at high cutting speed under minimum quantity lubrication
N1  - Cited by: 2
Y1  - 2024///
UR  - https://www.scopus.com/pages/publications/85205957405?origin=resultslist
N2  - This study focuses on investigating the cutting tool performance of a chemical vapor deposition (CVD) coated carbide tool in machining hardened AISI 4340 alloy steel under environmentally friendly sustainable minimum quantity lubrication (MQL) environment. The input parameters for turning experiments were configured in a high-speed regime, with the cutting speed (V) varying from 300 to 400 m/min, the feed rate (F) between 0.1 and 0.2 mm/rev, and depth of cut (DOC) in the range of 0.2 to 0.4 mm using a multilayer coated carbide tools TiCN/Al<sub>2</sub>O<sub>3</sub>. The experiments were randomly conducted using the Taguchi method L9 orthogonal array, which accommodated three factors, each with three levels. The longest tool life of 7.10 min was noticed under low machining parameters at a cutting speed, V=300 m/min, F=0.1 mm/rev, and DOC=0.2 mm. Analysis using S/N ratio revealed that the machining speed has a most profound influence on tool life in comparison to feed rate and depth of cut. Wear mechanisms such as cutting-edge chipping was commonly observed, whereas at high depth of cut catastrophic failure was noticed due to the flaking of the cutting tool material. © 2024, Malaysian Tribology Society (Mytribos). All rights reserved.
VL  - 42
ID  - scholars20588
SP  - 146 
PB  - Malaysian Tribology Society (Mytribos)
JF  - Jurnal Tribologi
AV  - none
SN  - 22897232
EP  -  160
ER  -