UTP ScholarsPerformance evaluation of multilayer coated carbide tools in machining hardened AISI430 at high cutting speed under minimum quantity lubricationJaharah A.GhaniauthorSaimaYaqoobauthorNabilJouiniauthorAfifah ZakiyyahJuriauthorChe Hassan CheHaronauthorShalina SheikMuhamadauthorThis study focuses on investigating the cutting tool performance of a chemical vapor deposition (CVD) coated carbide tool in machining hardened AISI 4340 alloy steel under environmentally friendly sustainable minimum quantity lubrication (MQL) environment. The input parameters for turning experiments were configured in a high-speed regime, with the cutting speed (V) varying from 300 to 400 m/min, the feed rate (F) between 0.1 and 0.2 mm/rev, and depth of cut (DOC) in the range of 0.2 to 0.4 mm using a multilayer coated carbide tools TiCN/Al<sub>2</sub>O<sub>3</sub>. The experiments were randomly conducted using the Taguchi method L9 orthogonal array, which accommodated three factors, each with three levels. The longest tool life of 7.10 min was noticed under low machining parameters at a cutting speed, V=300 m/min, F=0.1 mm/rev, and DOC=0.2 mm. Analysis using S/N ratio revealed that the machining speed has a most profound influence on tool life in comparison to feed rate and depth of cut. Wear mechanisms such as cutting-edge chipping was commonly observed, whereas at high depth of cut catastrophic failure was noticed due to the flaking of the cutting tool material. © 2024, Malaysian Tribology Society (Mytribos). All rights reserved.2024Malaysian Tribology Society (Mytribos)Article

For work being deposited by its own author: In self-archiving this collection of files and associated bibliographic metadata, I grant UTP Scholars the right to store them and to make them permanently available publicly for free on-line. I declare that this material is my own intellectual property and I understand that UTP Scholars does not assume any responsibility if there is any breach of copyright in distributing these files or metadata. (All authors are urged to prominently assert their copyright on the title page of their work.)

For work being deposited by someone other than its author: I hereby declare that the collection of files and associated bibliographic metadata that I am archiving at UTP Scholars is in the public domain. If this is not the case, I accept full responsibility for any breach of copyright that distributing these files or metadata may entail.

Clicking on the Deposit Item Now button indicates your agreement to these terms.