%0 Journal Article %@ 02540584 %A Al-Amin, M. %A Abdul-Rani, A.M. %A Rao, T.V.V.L.N. %A Danish, M. %A Rubaiee, S. %A Mahfouz, A.B. %A Parameswari, R.P. %A Wani, M.F. %D 2022 %F scholars:17175 %I Elsevier Ltd %J Materials Chemistry and Physics %K Additives; Amorphous alloys; Austenitic stainless steel; Carbides; Contact angle; Cracks; Hydroxyapatite; Mineral oils; Scanning electron microscopy; Surface defects, 316L steel; Electrodischarges; Erosion rates; Hydroxyapatite powder; Machining surfaces; Material erosion; Modified surfaces; Powder-mixed EDM; Recast layer; Surface characteristics, Carbon nanotubes %R 10.1016/j.matchemphys.2021.125320 %T Investigation of machining and modified surface features of 316L steel through novel hybrid of HA/CNT added-EDM process %U https://khub.utp.edu.my/scholars/17175/ %V 276 %X Hydroxyapatite powder (HAp) mixed-EDM process causes surface defects including a high roughness, crack and a thick recast layer attributing a low wettability and amorphous alloys as well as a low material erosion rate (MER) while processing the metallic biomaterials. To mitigate these occurrences, many measures have been conducted. This research aims to investigate the feasibility of hybrid HA and carbon nanotubes (CNT) powders mixed EDM process for processing 316L steel. This study also aims to explore the impacts of CNT and the associated variables on machining and surface characteristics of 316L steel. To ameliorate the machining and surface responses, a high electrically and thermally conductive CNT particles have been added in the HAp suspended mineral oil. To address the set objectives, several characterizations techniques including profilometer, goniometer, energy dispersive X-ray (EDX), X-ray diffraction (XRD), and scanning-electron microscope (SEM) have been carried out. In this study, the multiple additives (HAp and CNT) mixed-EDM process has been successfully introduced. Addition of the CNT in the HAp mixed mineral oil improves MER to 26.47 mg/min and declines SR to 3.16 μm. A thin uniform recast layer of 12.4 μm attributing cracks free surface and a high hydrophilic in nature having contact angle of 35° has been obtained in this study. Elemental composition analysis reveals a high content of Ca, P, O and C in the recast layer formed. The oxides, carbides, and CNT reinforced Ca-P based oxides with both crystalline and amorphous phases have been achieved. In this research work, a novel and effective method for processing the biomedical devices made of 316L steel has been proposed. © 2021 Elsevier B.V. %Z cited By 14