%K Basalt; Concrete beams and girders; Energy dissipation; Reinforced concrete; Software testing; Strain gages; Strain measurement; Sustainable development; Time domain analysis, ATENA; Basalt FRP; Brillouin optical time domain analysis; Control beams; Flexural behavior; FRP composite; Natural hybrid FRP; Natural jute FRP; Strain-gages; Strains measurements, Optical fibers
%X Experimental and finite element analysis results of reinforced concrete beams under monotonic loading were presented in this study. In the experimental program, one beam was tested in an as-built condition. The other two beams were strengthened using natural hybrid FRP layers in different configurations. The natural hybrid FRP composite was developed by using natural jute FRP and basalt FRP. One of the most appealing advantages of natural fiber is its beneficial impact on the environment, which is necessary for the sustainability recognition as an alternative to synthetic FRP. The hybrid FRP was applied to the bottom concrete surface in one beam, while a U-shaped strengthening pattern was adopted for the other beam. The flexural behavior of each beam was assessed through strain measurements. Each beam was incorporated with conventional strain gages, as well as the Brillouin Optical Time Domain Analysis (BOTDA) technique. BOTDA has its exclusive advantages due to its simple system architecture, easy implementation, measurement speed, and cross-sensitivity. The experimental results revealed that the beam strengthened with the U-shaped hybrid FRP composite pattern had a better flexural response than the other counterpart beams did both in terms of peak loads and maximum bottom longitudinal steel bar strains. Beams B-01 and B-02 exhibited 20.5 and 28.4 higher energy dissipation capacities than the control beam did, respectively. The ultimate failure of the control beam was mainly due to the flexural cracks at very low loads, whereas the ultimate failure mode of FRP composite-strengthened beams was due to the rupture of the hybrid FRP composite. Further, strain measurements using BOTDA exhibited similar patterns as conventional strain gage measurements did. However, it was concluded that BOTDA measurements were substantially influenced by the bottom flexural cracks, ultimately resulting in shorter strain records than those of conventional strain gages. Nonlinear structural analysis of the beams was performed using the computer program ATENA. The analytical results for the control beam specimen showed a close match with the corresponding experimental results mainly in terms of maximum deflection. However, the analytical peak load was slightly higher than the corresponding experimental value. © 2021 by the authors. Licensee MDPI, Basel, Switzerland.
%L scholars14379
%A K. Chaiyasarn
%A N. Ali
%A P. Phuphasuwan
%A N. Poovarodom
%A P. Joyklad
%A H. Mohamad
%A M. Zhou
%A Q. Hussain
%I MDPI
%J Polymers
%N 20
%R 10.3390/polym13203604
%D 2021
%O cited By 6
%T Flexural behavior of natural hybrid frp-strengthened rc beams and strain measurements using botda
%V 13