Meor Said , Mior Azman bin

Meor Said , Mior Azman bin

Ir. Dr.

Positions

Member, Center of Sustainable Resources for Intelligent and Efficient Mobility , Institute of Smart & Sustainable Living
Senior Lecturer, Mechanical Engineering Department , Faculty of Engineering
Senior Lecturer, Electrical & Electronic Engineering Department , Faculty of Engineering
Senior Lecturer, Universiti Teknologi PETRONAS 2012 -

member of

Mechanical Engineering Department

selected publications

academic article
- Biogas intake pressure and port air swirl optimization to enhance the diesel RCCI engine characteristics for low environmental emissions. Process Safety and Environmental Protection. 184:703-719. 2024
- Predicting the effects of direct-injected fuels co-powered by high-CO2 biogas on RCCI engine emissions using kinetic mechanisms and multi-objective optimization. Process Safety and Environmental Protection. 184:747-765. 2024
- Effects of High CO2 Contents on the Biogas/Diesel RCCI Combustion at Full Engine Load. Evergreen. 9:49-55. 2022
- Influence of biogas mixing parameters on the combustion and emission characteristics of diesel RCCI engine. Alexandria Engineering Journal. 61:1479-1497. 2022
- The evolution of a single droplet water-in-palm oil derived biodiesel emulsion leading to micro-explosion. Alexandria Engineering Journal. 61:541-547. 2022
- A Review on the Application of Multiphase Twin Screw Pump as a Downhole Wet Gas Compressor to Improve Gas Wells Recovery Factor. International Journal of Mechanics. 15:223-232. 2021
- An Outlook on Tar Abatement, Carbon Capture and its Utilization for a Clean Gasification Process. Evergreen. 8:717-731. 2021
- Assessing the implementation levels of oil palm waste conversion methods in Malaysia and the challenges of commercialisation: Towards sustainable energy production. Biomass and Bioenergy. 151:106179. 2021
- Effects of port mixing and high carbon dioxide contents on power generation and emission characteristics of biogas-diesel RCCI combustion. Applied Thermal Engineering. 198:117449. 2021
- Experimental study on recoverable thermal energy from low thermal inertia exhaust heat recovery unit. Advances in Mechanical Engineering. 13:168781402110260. 2021
- Syngas production from gasification and co‐gasification of oil palm trunk and frond using a down‐draft gasifier. International Journal of Energy Research. 45:8103-8115. 2021
- An Experimental Investigation on the Influence of Port Injection at Valve on Combustion and Emission Characteristics of B5/Biogas RCCI Engine. Applied Sciences. 10:452. 2020
- Numerical investigation on the effect of bileaflet mechanical heart valve's implantation tilting angle and aortic root geometry on intermittent regurgitation and platelet activation. Artificial Organs. 44. 2020
- Numerical investigation on the relationship of cavitation initiation in bileaflet mechanical heart valves (BMHVs) with the aortic root geometry and valve’s implantation rotation angle. Journal of the Brazilian Society of Mechanical Sciences and Engineering. 42:23. 2020
- Investigation of Fuel Characterisation of Waste Sludge from Sewage Treatment Plants (STP). MATEC Web of Conferences. 225:04019. 2018
- Properties of glycerol and ethylene glycol mixture based SiO2-CuO/C hybrid nanofluid for enhanced solar energy transport. Solar Energy Materials and Solar Cells. 179:118-128. 2018
- Wall Heat Transfer Analysis of Internal Combustion Engine with Free Piston Linear Motion. International Journal of Engineering & Technology. 7:141. 2018
- Effect of producer gas staged combustion on the performance and emissions of a single shaft micro-gas turbine running in a dual fuel mode. Journal of the Energy Institute. 90:132-144. 2017
- Experimental Investigation of Micro-Gas Turbine Performance at Reduced Air Inlet Temperature. MATEC Web of Conferences. 131:01011. 2017
- Investigation on microstructure and mechanical properties on varying surface region of a service-exposed IN738 turbine blade. International Journal of Microstructure and Materials Properties. 12:38. 2017
- Numerical investigation on effect of aortic root geometry on flow induced structural stresses developed in a bileaflet mechanical heart valve. Journal of Physics: Conference Series. 908:012039. 2017
- Numerical investigation on effect of leaflet thickness on structural stresses developed in a bileaflet mechanical heart valve for its sustainable manufacturing. MATEC Web of Conferences. 131:04004. 2017
- Determination of Remaining Useful Life of Gas Turbine Blade. MATEC Web of Conferences. 38:01011. 2016
- A Review of the Utilisation of Natural Gas with High Carbon Dioxide Content as Automotive Fuel in an Indirect Injection Diesel Engine. MATEC Web of Conferences. 13:02026. 2014
- Effect of Syngas Moisture Content on the Emissions of Micro-Gas Turbine Fueled with Syngas/LPG in Dual Fuel Mode. MATEC Web of Conferences. 13:02012. 2014
- Instantaneous Heat Flux Simulation of a Motored Reciprocating Engine: Unsteady Thermal Boundary Layer With Variable Turbulent Thermal Conductivity. Journal of Heat Transfer. 136. 2014
- Engine performance and emission analysis of LPG-SI engine with the aid of artificial neural network. Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy. 225:591-600. 2011
- Performance and emission investigation of a four-stroke liquefied petroleum gas spark-ignition engine generator used in a Malaysian night market. Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy. 224:339-347. 2010
chapter
- Determining the Influencing Factors for Micro-Explosion of Emulsified Biodiesel Fuel. Lecture Notes in Mechanical Engineering. 133-146. 2023
- An Overview of Biomass Conversion Technologies in Nigeria. Clean Energy Opportunities in Tropical Countries. 133-150. 2021
- Palm Kernel Shell as Potential Fuel for Syngas Production. Lecture Notes in Mechanical Engineering. 263-273. 2020
- Reactivity Controlled Compression Ignition: An Advanced Combustion Mode for Improved Energy Efficiency. Energy Efficiency in Mobility Systems. 101-126. 2020
- Waste Heat Recovery from a Gas Turbine: Organic Rankine Cycle. Sustainable Thermal Power Resources Through Future Engineering. 37-47. 2019
conference paper
- A review on the autonomous technology in ASEAN NCAP. INTERNATIONAL SYMPOSIUM ON GREEN AND SUSTAINABLE TECHNOLOGY (ISGST2019). 2023
- Numerical simulation of the non-Newtonian blood flow through aortic Bileaflet mechanical heart valve using fluid-structure interaction approach. INTERNATIONAL SYMPOSIUM ON GREEN AND SUSTAINABLE TECHNOLOGY (ISGST2019). 2018
- Strategies and methods of RCCI combustion: A review. INTERNATIONAL SYMPOSIUM ON GREEN AND SUSTAINABLE TECHNOLOGY (ISGST2019). 2018
- Experimental determination of nanofluid specific heat with SiO2 nanoparticles in different base fluids. INTERNATIONAL SYMPOSIUM ON GREEN AND SUSTAINABLE TECHNOLOGY (ISGST2019). 2017
- A review of radiation heat transfer measurement for diesel engines using the two-colour method 2009
- Numerical Simulation of Natural Convection Heat Transfer in Nanofluids 2005

education and training

Ph.D., Universitiy of Southern Queensland 2013
M.Sc. in Mechanical Engineering, Washington University in St. Louis 2005
B.Sc. in Mechanical Engineering, Universiti Tenaga Nasional Malaysia 2001

full name

Mior Azman bin Meor Said

primary email

miorazman@utp.edu.my

webpage

Publications in VIVO

Co-author Network

Contact Info

miorazman@utp.edu.my

Websites